Description
Need an accurate, inexpensive vacuum gripper solution for your robot? Look no further.
This Vacuum Gripper Mount for the Revel Robotic Arm allows enables your robot to starting interacting with the world through the power of pressure.
The mount has interchangeable bellows at the top, allowing for you to choose the correct suction cup for your specific application. At the bottom, the mount’s swivel type vacuum port accepts any 1/4″ OD tubing, allowing for connection with Svenzva’s own ultra quiet Vacuum Pump system or your existing vacuum system.
The mount itself is made from a single piece of durable, lightweight HDPE while the fittings used in this mount are made of brass. All this sums up to a high quality product with a low total weight so as not to greatly impact the robot’s payload.
What’s Included?
1 x fully assembled Revel Vacuum Gripper Mounting unit which contains
1 Nitrile Rubber (NBR) 20mm vacuum pad bellows
1 brass barbed tube fitting for vacuum pad
1 1/4″ push-to-connect swivel tube port (brass and plastic construction)
1 single-piece HDPE mount
Additional Information
Maximum rated pressure for assembly: 100 psi @ 72° F
Allowable rated temperature range: 0° F to 170° F
Mount dimension L x W x H: 5.08cm x 4.32cm x 2.03cm
Please note that this product will not mount directly to the Revel Robotic Arm’s standard finger set. In order to mount and use this product you must use Svenzva’s Revel Mounting Finger Set.
NOTE: this product is not yet for sale. The above information is for reference only and is subject to change prior to product release.
